Nonlinear numerical analysis of nine reinforced concrete beams with dimensions (150 x 200 x 1200) width, height and length, respectively, was carried out through the finite element theory using the ANSYS software (version 15) to know the effect of different properties of layers in the one beam on the flexural behavior of reinforced concrete beams. The beams are consisting from two layers for the one cross-section. three beams are similar properties layers and the other six are with different properties layers. The beams differ among them depending on the percentage of Polyethylene terephthalate (PET) fibers added, the location of the fibrous concrete layer as well as the thickness of the layer. PET fibers were added in proportions (0%,0.5%, and 1%) from volume of the one layer, with dimension (50 x 4 x 0.3) mm length, width, and thickness respectively. All beams are reinforced with steel reinforcement (6 mm diameter at the top, 10 mm diameter for reinforcement against shear and 12 mm diameter in the tension area). The mechanical properties of each type of mixture have been studied. It was found that the different properties of the layers significantly affected the flexural behavior of reinforced concrete beams. Also the results of the numerical modeling were very close to the laboratory results obtained from the practical study, where the largest difference between the two studies was 8% and 11% for the load and deflection respectively at the ultimate point
This paper presents the testing results and numerical results of nine reinforced concrete thick slabs with and without openings. All slab specimens have the same planar dimensions (1000mm×1000mm) with three different thicknesses of (120mm,100mm,and 80mm).The slabs resting on 4 corner steel columns and tested under concentrated static loading up to failure. These slabs were also analyzed using nonlinear finite element method assuming nonlinear material properties. From the experiments, it was found that, The presence of openings in slabs supported on their four corners decreases the strength and rigidity of slabs to about (12-23) % depending on the slab thicknesses and the shape of these openings. The slabs with (circular opening) recorded a reduction in ultimate strength to about(20) % from those with square openings having an equivalent opening areas. The yielding of main steel reinforcement occurred at load about 85% of the slab ultimate load. The ultimate loads predicted by ANSYS model have showed a good agreement with the experimental results.